DIGICAM -TRENDY

                    Ni-MH Charger for 2 or 4 AA-AAA Batteries

                    TECHNICAL SPECIFICATIONS

                     INPUT : AC 100-270V, 50Hz

                     OUTPUT : DC 1.2V x 2 … 220mA (AA/AAA)
                     DC 1.2V x 4 … 160mA (AA/AAA)

                     CHARGING TIME: 3-5Hours for 600-1000mAh AAA
                     4-5 Hours for AA700-1000mAh Battery
                     10-14 Hours for AA2100-2700mAh

                     CHARGING INDICATIONS:

                     Insert 2 cells single LED glows (Charging-ON)
                     Insert 4 cells both LED glows (Charging-ON)

                     SAFETY: This Charger is designed to meet Indian Power Conditions
                     It delivers you same Charging time from AC100 to 270Volts.
                     No over-heating to the Batteries or the Charger.

                     CAUTION:
                     * For Indoor Use Only, Don’t try to operate in moisture or wet conditions.
                     * Keep the Batteries & Charger in Cool & Dry locations.
                     * Take out the Batteries after Full Charging or Disconnect Mains.
                     * Do not overcharge the Batteries to get its maximum Cycle-life.
                     * Use DIGICAM –RTU (Ready to Use) Batteries for best Results.
                     * RTU- Battery can be used even after 6-months after full-Charge once.

                     Note: The above specifications can be changed w/o prior intimation.

                     A product of Montu Electronics-Delhi, E-mail info@montuelectronics.com